Volumetric Heat Transfer Coefficient in Fluidized-Bed Dryers-Reference-Cited by-同舟云学术

Volumetric Heat Transfer Coefficient in Fluidized-Bed Dryers

Published:2018-01-31 Issue:3 Volume:41 Page:628-636
ISSN:0930-7516
Container-title:Chemical Engineering & Technology
language:en
Short-container-title:Chem. Eng. Technol.

Author:

Poós Tibor¹,Szabó Viktor¹

Affiliation:

1. Budapest University of Technology and Economics; Faculty of Mechanical Engineering, Department of Building Services and Process Engineering; Műegyetem rakpart 3-9 1111 Budapest Hungary

Funder

Gedeon Richter's Talentum Foundation

Hungarian Scientific Research Found

Publisher

Wiley

Subject

Industrial and Manufacturing Engineering,General Chemical Engineering,General Chemistry

Reference28 articles.

1. Handbook of Fluidization and Fluid-Particle Systems

2. A model for the thermodynamic analysis in a batch type fluidized bed dryer

3. Measurement Techniques to Monitor and Control Fluidization Quality in Fluidized Bed Dryers: A Review

4. Performance investigation of liquid-to-air membrane energy exchanger under low solution/air heat capacity rates ratio conditions

Cited by 11 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental investigation on volumetric heat transfer coefficient during intermittent spray drying of mannitol solution;Drying Technology;2023-05-24

2. Heat and mass transfer characteristics during spray drying of Na2Fe0.6Mn0.4PO4F/C cathode material for Na-ion batteries;Applied Thermal Engineering;2023-02

3. Investigation of The Droplet Properties Along Their Trajectory in The Cooling Tower;2021 3rd International Conference on Research and Academic Community Services (ICRACOS);2021-10-09

4. Modeling of heat and mass transfer in fluidized bed dryers using the volumetric heat transfer coefficient. Part 1: Equations describing the simultaneous heat and mass transfer;Drying Technology;2021-08-30

5. Modeling of heat and mass transfer in fluidized bed dryers using the volumetric heat transfer coefficient. Part 2: calculation algorithm based on the heat and mass transfer model;Drying Technology;2021-07-08