Evaluation of the influence of a wear-resistant coating on the process of turning a titanium alloy-Reference-Cited by-同舟云学术

Evaluation of the influence of a wear-resistant coating on the process of turning a titanium alloy

Published:2022-10-22 Issue:10 Volume:2022 Page:14-21
ISSN:2223-4608
Container-title:Science intensive technologies in mechanical engineering
language:en
Short-container-title:

Author:

Pyatykh Aleksey¹,Timofeev Sergey²

Affiliation:

1. Irkutsk State Technical University

2. Irkutskiy nacional'nyy issledovatel'skiy tehnicheskiy universitet,

Abstract

The results of a study of the machinability of titanium alloy VT1-0 are presented. The influence of the wear-resistant coating of the cutting tool on the cutting forces is analyzed. It is shown that when turning with a cutting tool without a wear-resistant coating, the cutting forces and friction force are lower than when turning with a tool with a coating. Based on the applied Taguchi method, effective cutting conditions were selected, at which maximum productivity is achieved

Publisher

Bryansk State Technical University BSTU

Subject

General Earth and Planetary Sciences,General Environmental Science

Reference10 articles.

1. URL: https://viam.ru/review/5202, URL: https://viam.ru/review/5202

2. Geetha, M., Singh, A.K., Asokamani, R., Gogia, A.K. Ti based biomaterials, the ultimate choice for orthopaedic implants – A review // Progress in Materials Science. – 2009. – №54 (3). – P. 397-425., Geetha, M., Singh, A. K., Asokamani, R., Gogia, A. K. Ti based biomaterials, the ultimate choice for orthopaedic implants – A review // Progress in Materials Science. - 2009. No. 54 (3). P. 397-425.

3. Giacaglia, G.E.O., Lamas, W. de Q. Pedicle screw rupture: A case study // Case Studies in Engineering Failure Analysis. – 2015. – №4. – P. 64-75., Giacaglia, G. E. O., Lamas, W. de Q. Pedicle screw rupture: A case study // Case Studies in Engineering Failure Analysis. - 2015. No. 4. P.64-75.

4. Multi-response optimization in high-speed machining of Ti-6Al-4V using TOPSIS-fuzzy integrated approach / Abbas A.T., Sharma N., Anwar S. et al. // Materials (Basel), – 2020. – Р. 1104., Abbas, A.T., Sharma, N., Anwar, S., Luqman, M. et al. Multi-response optimization in high-speed machining of Ti-6Al-4V using TOPSIS-fuzzy integrated approach. Materials (Basel), - 2020. - 1104 P.

5. Savilov, A.V., Timofeev, S.A., Svinin, V.M. Investigation of Output Parameters of Titanium Reverse Turning // Journal of Physics: Conference Series : International Conference Information Technologies in Business and Industry 2018 – Enterprise Information Systems, Tomsk, 17–20 января 2018 года. – Tomsk: Institute of Physics Publishing, 2018. – P. 042055., Savilov, A.V., Timofeev, S.A., Svinin, V.M. Investigation of Output Parameters of Titanium Reverse Turning / A. V. Savilov, V. M. Svinin, S. A. // Journal of Physics: Conference Series : International Conference Information Technologies in Business and Industry 2018 - Enterprise Information Systems, Tomsk, January 17–20, 2018. – Tomsk: Institute of Physics Publishing, 2018. – P. 042055.