Collapse loads for thin cantilevers with rectangular holes along the centre-line

Abstract

Plane stress slip-line field solutions, which provide the modes of yielding and the corresponding yield loads, are presented for the plastic bending of end-loaded thin cantilevers of rectangular cross-section containing rectangular holes. The theoretical results obtained from these solutions are compared with some experimental results and those obtained from plane strain slip-line fields and lower bound estimates, all presented previously by the authors (1)‡. It is observed that the correlation of the experimental results was much better with the plane stress solutions than with either the plane strain or lower bound results.The effect of adjacent holes and possible lateral or local buckling on the ultimate strength of the cantilevers is also examined.