PREVENTING FLASH OCCURRENCE IN THE INJECTION PLASTIC MOULD
-
Published:2022-09-27
Issue:3
Volume:2022
Page:5854-5857
-
ISSN:1803-1269
-
Container-title:MM Science Journal
-
language:
-
Short-container-title:MM SJ
Author:
HABRMAN MARTIN, ,CHVAL ZDENEK,RAZ KAREL,STREIT PHILIPP,STUEMPFL DOMINIK, , , ,
Abstract
This article deals with the injection moulding into the plastic mould. This is an unconventional approach to injection moulding, especially because the 3D printing is used to produce the mould. The mould with the same shape was made of a conventional material (aluminium) for comparison. The properties of the plastic mould were then compared to the aluminium mould. The flash was seen as the main shortcoming. The modifications of the mould were suggested in two variants, one of them was implemented. The advantage of the flash solution was described. Finally, other solution options were summarized based on the performed testing.
Publisher
MM Publishing, s.r.o.
Subject
Electrical and Electronic Engineering,Industrial and Manufacturing Engineering,Mechanical Engineering,Automotive Engineering