Identification and characterization of spatter particles and their effect on surface roughness, density and mechanical response of 17-4 PH stainless steel laser powder-bed fusion parts-Reference-Cited by-同舟云学术

Identification and characterization of spatter particles and their effect on surface roughness, density and mechanical response of 17-4 PH stainless steel laser powder-bed fusion parts

Published:2019-05 Issue: Volume:756 Page:98-107
ISSN:0921-5093
Container-title:Materials Science and Engineering: A
language:en
Short-container-title:Materials Science and Engineering: A

Author:

Ali Usman,Esmaeilizadeh Reza,Ahmed Farid,Sarker Dyuti,Muhammad Waqas,Keshavarzkermani Ali,Mahmoodkhani Yahya,Marzbanrad Ehsan,Toyserkani Ehsan

Funder

Natural Sciences and Engineering Research Council of Canada

Federal Economic Development Agency for Sothern Ontario (FedDev Ontario)

Publisher

Elsevier BV

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Reference50 articles.

1. Additive manufacturing of metals: A review;Herderick;Mater. Sci. Technol. Conf. Exhib.,2011

2. (Re)Designing for Part Consolidation: understanding the challenges of metal additive manufacturing;Schmelzle;J. Mech. Des.,2015

3. A critical review of powder-based additive manufacturing of ferrous alloys: process parameters, microstructure and mechanical properties;Fayazfar;Mater. Des.,2018

4. On the measurement of relative powder-bed compaction density in powder-bed additive manufacturing processes;Ali;Mater. Des.,2018

5. Gas flow effects on selective laser melting (SLM) manufacturing performance;Ferrar;J. Mater. Process. Technol.,2012

Cited by 99 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Optimization of in-situ laser remelting parameters for enhancing mechanical properties of parts produced by laser powder bed fusion process;Optics & Laser Technology;2025-02

2. Anomalous temperature-dependent strength of copper alloy manufactured by laser-beam powder bed fusion;Additive Manufacturing Letters;2024-12

3. On the nature and causes of spatter redistribution in laser powder bed fusion;Journal of Manufacturing Processes;2024-10

4. Interaction of contour and hatch parameters on vertical surface roughness in laser powder bed fusion;Journal of Materials Research and Technology;2024-09

5. Effect of Preprocessing Temperature On the Recycling of Waste Direct Metal Laser Sintering Powder;Transactions of the Indian Institute of Metals;2024-07-24