Effect of working temperature on the interfacial behavior of overmolded hybrid fiber reinforced polypropylene composites-Reference-Cited by-同舟云学术

Effect of working temperature on the interfacial behavior of overmolded hybrid fiber reinforced polypropylene composites

Published:2020-11 Issue: Volume:91 Page:106870
ISSN:0142-9418
Container-title:Polymer Testing
language:en
Short-container-title:Polymer Testing

Author:

Fu Liang,Ding Yudong,Weng Can,Zhai Zhanyu,Jiang Bingyan

Funder

Fundamental Research Funds for Central Universities of the Central South University

State Key Laboratory of High Performance Complex Manufacturing

Publisher

Elsevier BV

Subject

Polymers and Plastics,Organic Chemistry

Reference27 articles.

1. Fiber distribution of long fiber reinforced polyamide and effect of fiber orientation on mechanical behavior;Zhu;Polym. Compos.,2020

2. Tensile behavior of quasi-unidirectional glass fiber/polypropylene composites at room and elevated temperatures;Zhai;Polym. Test.,2016

3. Investigations on low-energy impact and post-impact fatigue of adhesively bonded single-lap joints using composites substrates;Huang;J. Adhes.,2019

4. Experimental investigation of a new hybrid molding process to manufacture high-performance composites;Fiorotto;Int. J. Material Form.,2011

5. Experimental investigation on mechanical properties and failure mechanisms of polymer composite-metal hybrid materials processed by direct injection-molding adhesion method;Li;J. Mater. Process. Technol.,2019

Cited by 17 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effect of prefabricating process on remelting interfacial properties for thermoplastic composite stiffened structures: Molecular dynamics simulation and experimental verification;Polymer;2024-06

2. Effect of polymer crosslinking to the failure behavior of thermoplastic composite remelting interface: Molecular dynamics simulation and experimental verification;Polymer Composites;2024-05-28

3. Modeling of a Process Window for Tailored Reinforcements in Overmolding Processes;Journal of Composites Science;2024-02-08

4. Influence of Processing Conditions on the Generation of Surface Defects in a Heat-and-Cool Hybrid Injection Molding Technique for Carbon Fiber-Reinforced Thermoplastic Sheets and Development of a Suitable Mold Heated by Far-Infrared Radiation;Polymers;2023-11-16

5. Effects of graphene pull‐out on the interfacial mechanical properties of alumina/graphene nanocomposite ceramic tool materials: Molecular dynamics analysis and material preparation;International Journal of Applied Ceramic Technology;2023-09-05