A method for the evaluation of a ratchet limit and the amplitude of plastic strain for bodies subjected to cyclic loading-Reference-Cited by-同舟云学术

A method for the evaluation of a ratchet limit and the amplitude of plastic strain for bodies subjected to cyclic loading

Published:2001-07 Issue:4 Volume:20 Page:555-571
ISSN:0997-7538
Container-title:European Journal of Mechanics - A/Solids
language:en
Short-container-title:European Journal of Mechanics - A/Solids

Author:

Chen Haofeng,Ponter Alan R.S

Publisher

Elsevier BV

Subject

General Physics and Astronomy,Mechanical Engineering,Mechanics of Materials,General Materials Science

Reference20 articles.

1. Approximate inelastic analysis of defective components;Ainsworth;Nucl. Eng. Des.,1992

2. Simple method of calculating lower-bound limit loads for axisymmetric thin shells;Boyle;J. Pres. Ves. Tech.,1997

3. On the solution of limit load and reference stress of 3-D structures under multi-loading systems;Chen;Eng. Struct.,1999

4. Chen, H.F., Ponter, A.R.S., 2000. The 3-D shakedown & limit analyses using elastic compensation method. Department of Engineering, University of Leicester

5. A numerical method for lower bound limit analysis of 3-D structures with multi-loading systems;Chen;Int. J. Pres. Ves. Pip.,1999

Cited by 99 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Extended constant life diagrams for low cycle fatigue and creep-fatigue assessments of high-temperature structures;Engineering Structures;2024-06

2. Plastic behavior and shakedown limit of defected pressurized pipe under cyclic bending moment;Journal of Engineering and Applied Science;2024-05-04

3. Thermomechanical shakedown analysis considering temperature-dependent yield stress based on the primal-dual eigenstress-driven method;International Journal of Mechanical Sciences;2024-01

4. A short review of ratcheting effect in pressurized piping;International Journal of Pressure Vessels and Piping;2023-10

5. Experimental and numerical investigations on buckling behaviours of axially compressed cylindrical–conical–cylindrical shells at elevated temperature;Thin-Walled Structures;2023-03