Comparative study of constitutive modeling for Ti–6Al–4V alloy at low strain rates and elevated temperatures-Reference-Cited by-同舟云学术

Comparative study of constitutive modeling for Ti–6Al–4V alloy at low strain rates and elevated temperatures

Published:2014-03 Issue: Volume:55 Page:999-1005
ISSN:0261-3069
Container-title:Materials & Design
language:en
Short-container-title:Materials & Design

Author:

Kotkunde Nitin,Deole Aditya D.,Gupta Amit Kumar,Singh Swadesh Kumar

Publisher

Elsevier BV

Subject

Applied Mathematics,General Mathematics

Reference35 articles.

1. A study of the microstructure and hardness of two titanium alloys: commercially pure and Ti–6Al–4V;Poondla;J Alloy Compd,2009

2. Hot working of commercial Ti–6Al–4V with an equiaxed α–β microstructure: materials modeling considerations;Seshacharyulu;Mater Sci Eng A,2000

3. Deformation mechanisms of Ti–6Al–4Vduring tensile behavior at low strain rate;Vanderhasten;J Mater Eng Perform,2007

4. Beal Joseph D, Boyer Rodney, Sanders Daniel. Forming of titanium and titanium alloys. ASM handbook. Metalworking: sheet forming, vol. 14B. The Boeing Company; p. 656–69.

5. Effect of the strain on the deformation behavior of isothermally compressed Ti–6Al–4V alloy;Luo;Mater Sci Eng A,2009

Cited by 149 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effectiveness of thermoviscoplastic material models in predicting the thermomechanical behavior of rolled homogenous armor steel;Physica Scripta;2024-07-30

2. Dynamic constitutive model of Fe–Cr–Ni stainless steel based on isothermal true stress-strain curves;Journal of Materials Research and Technology;2024-07

3. Crystal plasticity based constitutive model for deformation in metastable β titanium alloys;Modelling and Simulation in Materials Science and Engineering;2024-05-31

4. Compressive mechanical behavior of B2 FeAl-based metal-intermetallic laminate composites;Journal of Materials Science;2024-05-19

5. Mechanical characterization and behavior modelling of Ti-6Al-4V alloy in hot forming conditions;Materials Research Proceedings;2024-05-15