Evolution of mechanical properties in a 7075 Al-alloy subject to natural ageing-Reference-Cited by-同舟云学术

Evolution of mechanical properties in a 7075 Al-alloy subject to natural ageing

Published:2013-08 Issue: Volume:49 Page:160-167
ISSN:0261-3069
Container-title:Materials & Design
language:en
Short-container-title:Materials & Design

Author:

Leacock Alan G.,Howe Conrad,Brown Desmond,Lademo Odd-Geir,Deering Alan

Publisher

Elsevier BV

Subject

Applied Mathematics,General Mathematics

Reference28 articles.

1. Howe C. A tool design method for the compensation of springback in sheet hydroformed components. Ph.D. thesis. Faculty of Computing and Engineering of The University of Ulster; 2007.

2. Materials selection in design of structures and engines of supersonic aircrafts: a review;Huda;Mater Des,2013

3. Calorimetric studies of precipitation and dissolution kinetics in aluminum alloys 2219 and 7075;Papazian;Metall Trans A [Phys Metall Mater Sci],1982

4. Microanalytical study of the heterogeneous phases in commercial Al–Zn–Mg–Cu alloys;Ayer;Metall Trans A [Phys Metall Mater Sci],1985

5. In-situ small-angle X-ray scattering study of dynamic precipitation in an Al–Zn–Mg–Cu alloy;Deschamps;Philos Mag,2003

Cited by 47 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Assessment of the Microstructural Evolution of Naturally Aged Open-Cell Al-1.96Cu (at.%) Foams;Metallography, Microstructure, and Analysis;2024-08-27

2. Study the mechanical and morphological properties of aluminium alloy 7075 by aging treatments;Materials Today: Proceedings;2024-06

3. Numerical and analytical analyses of the formability and fracture of AA7075-O aluminum sheets in hemispherical punch tests;International Journal of Solids and Structures;2024-01

4. Influence of Stainless Steel Short Fibres as Reinforcements in Enhancing the Performance of Aluminium 7075 Alloy Matrix Composites;Transactions of the Indian Institute of Metals;2023-10-21

5. Room Temperature Stamping of High-Strength Aluminum for Lightweight Structural Automotive Components;Journal of Materials Engineering and Performance;2023-10-19