Tensile properties of 3D-printed CNT-SGF reinforced PLA composites-Reference-Cited by-同舟云学术

Tensile properties of 3D-printed CNT-SGF reinforced PLA composites

Published:2022-11 Issue: Volume:230 Page:109333
ISSN:0266-3538
Container-title:Composites Science and Technology
language:en
Short-container-title:Composites Science and Technology

Author:

Zhao Guixiang^ORCID,Liu Hong-Yuan,Cui Xiaoyu^ORCID,Du Xusheng,Zhou Helezi^ORCID,Mai Yiu-Wing,Jia Yuan-Yuan,Yan Wenyi^ORCID

Funder

Australian Research Council

Publisher

Elsevier BV

Subject

General Engineering,Ceramics and Composites

Reference25 articles.

1. Functional fillers in composite filaments for fused filament fabrication; a review;Angelopoulos;Mater. Today Proc.,2021

2. Polishing of fused deposition modeling products by hot air jet: evaluation of surface roughness;Adel;J. Mater. Process. Technol.,2018

3. 3D printing of polymer matrix composites: a review and prospective;Wang;Compos. B Eng.,2017

4. Investigation of processing parameters on tensile performance for FDM-printed carbon fiber reinforced polyamide 6 composites;Peng;Compos. Commun.,2020

5. Development of short basalt fiber reinforced polylactide composites and their feasible evaluation for 3D printing applications;Sang;Compos. B Eng.,2019

Cited by 21 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. 3D printing of functionally graded nanocomposites: An investigation of microstructural, rheological, and mechanical behavior;Polymer Engineering & Science;2024-07-21

2. Fabrication, characterization and evaluating properties of 3D printed PLA-Mn scaffolds;Scientific Reports;2024-07-18

3. Mechanical, physical and thermal properties of polylactic acid filament composite reinforced with newly isolated Cryptostegia grandiflora fiber;BioResources;2024-04-25

4. Mechanical properties of additively manufactured polymeric composites using sheet lamination technique and fused deposition modeling: A review;Polymers for Advanced Technologies;2024-04

5. Fabrication of a sensor based on the FDM-printed CNT/PA6 dielectric layer with Hilbert fractal microstructure;Sensors and Actuators A: Physical;2024-04