Co-optimization of injection parameters and injector layouts for a methanol/diesel direct dual-fuel stratification (DDFS) engine-Reference-Cited by-同舟云学术

Co-optimization of injection parameters and injector layouts for a methanol/diesel direct dual-fuel stratification (DDFS) engine

Published:2023-12 Issue: Volume:284 Page:128647
ISSN:0360-5442
Container-title:Energy
language:en
Short-container-title:Energy

Author:

Li Yaopeng,Li Hua,Pang Bin,Liu Fei,Jia Ming,Long Wuqiang,Tian Jiangping,Guo Lijun

Publisher

Elsevier BV

Subject

General Energy,Pollution,Mechanical Engineering,Building and Construction,Electrical and Electronic Engineering,Industrial and Manufacturing Engineering,Civil and Structural Engineering

Reference53 articles.

1. Review of the regulations and techniques to eliminate toxic emissions from diesel engine cars;Olabi;Sci Total Environ,2020

2. A review on regulations, current status, effects and reduction strategies of emissions for marine diesel engines;Ni;Fuel,2020

3. Homogeneous charge compression ignition (HCCI) engines-a review on the technology for posterity;Varh;Int J Eng Res Technol,2020

4. Numerical investigation of soot formation mechanisms in partially-premixed ethylene–air co-flow flames;Chernov;Combust Flame,2012

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effects of ammonia energy ratio and PODE injection timing on combustion and emissions in a PODE/ammonia RCCI engine;Fuel;2024-12

2. Experimental investigation of knock control criterion considering power output loss for a PFI SI methanol marine engine;Energy;2024-09

3. A full-parameter computational optimization of both injection parameters and injector layouts for a methanol/diesel dual-fuel direct injection compression ignition engine;Fuel;2024-08

4. Influence of critical parameters on combustion and emission characteristics of methanol/diesel dual fuel compression combustion engine;Fuel;2024-07

5. Optimization of methanol/diesel dual-fuel engines at low load condition for heavy-duty vehicles to operated at high substitution ratio by using single-hole injector for direct injection of methanol;Applied Thermal Engineering;2024-06