Improved inverse filter for the correction of distorted measured cutting forces-Reference-Cited by-同舟云学术

Improved inverse filter for the correction of distorted measured cutting forces

Published:2017-01 Issue: Volume:120 Page:276-285
ISSN:0020-7403
Container-title:International Journal of Mechanical Sciences
language:en
Short-container-title:International Journal of Mechanical Sciences

Author:

Wan Min,Yin Wei,Zhang Wei-Hong,Liu Hui

Publisher

Elsevier BV

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science,Civil and Structural Engineering

Reference22 articles.

1. Three dimensional cutting force analysis in end milling;Zheng;Int J Mech Sci,1996

2. Study of static and dynamic ploughing mechanisms by establishing generalized model with static milling forces;Wan;Int J Mech Sci,2016

3. Gautschi GH. Cutting forces in machining and their routine measurement with multi-component piezo-electric force transducers. In: Proceedings of 12th international machine tool design and research, Manchester; 1971. p. 113–20.

4. Theoretical calculation and experimental analyses of natural frequency for high frequency dynamometer;Huang;China Mech Eng,2015

5. Tlusty J, Jang D, Tarng Y. Measurements of milling force over a wide frequency range. In: Proceedings of the 15th NAMRC. Bethlehem, PA: Lehigh University; 1987. p. 273–80.

Cited by 28 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Development of a universal, machine tool independent dynamometer for accurate cutting force estimation in milling;International Journal of Machine Tools and Manufacture;2024-05

2. Superresolution Restoration of Cutting Forces in Thin-Walled Milling With a Diffusion Model;IEEE/ASME Transactions on Mechatronics;2024

3. Online chatter detection for single-point diamond turning based on multidimensional cutting force fusion;Mechanical Systems and Signal Processing;2024-01

4. Dynamic force identification in milling based on IRLS using acceleration signals;Measurement;2023-08

5. Online identification of milling forces using acceleration signals;The International Journal of Advanced Manufacturing Technology;2023-06-27