Characterization of Al3Zr precipitation via double-step homogenization and recrystallization behavior after subsequent deformation in 2195 Al-Li alloy-Reference-Cited by-同舟云学术

Characterization of Al3Zr precipitation via double-step homogenization and recrystallization behavior after subsequent deformation in 2195 Al-Li alloy

Published:2021-12 Issue: Volume:182 Page:111549
ISSN:1044-5803
Container-title:Materials Characterization
language:en
Short-container-title:Materials Characterization

Author:

Guo You-Jie,Li Jin-Feng,Lu Ding-Ding,Deng San-Xi,Zeng Guang-Jun,Ma Yun-Long,You Wen,Chen Yong-Lai,Zhang Xu-Hu,Zhang Rui-Feng

Publisher

Elsevier BV

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Reference50 articles.

1. Progress in structural materials for aerospace systems;Williams;Acta Mater.,2003

2. Microstructure evolution and precipitation characteristics of spray-formed and subsequently extruded 2195 Al-Li alloy plate during solution and aging process;Zhang;J. Mater. Process. Technol.,2020

3. Microstructure evolution of spray deposited and as-cast 2195 Al-Li alloys during homogenization;Wang;J. Mater. Sci. Technol.,2021

4. Microstructural evolution of Mg, Ag and Zn micro-alloyed Al-Cu-Li alloy during homogenization;Liu;Trans. Nonferrous Metals Soc.,2016

5. Effect of minor Sc and Fe co-addition on the microstructure and mechanical properties of Al-Cu alloys during homogenization treatment;Gao;Mater. Sci. Eng. A,2019

Cited by 50 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Heat-balance control of friction rolling additive manufacturing based on combination of plasma preheating and instant water cooling;Journal of Materials Science & Technology;2025-01

2. Microstructure and mechanical properties of cast Al-Li-Mg alloy: Role of Cu addition and heat treatment;Journal of Materials Science & Technology;2024-11

3. Achieving low hot tearing susceptibility in high-strength cast Al–Li alloys: Experimental investigation and simulation assessment;Materials Science and Engineering: A;2024-09

4. Microstructure evolution and thermal stability of L12-Al3Zr dispersoids in Al-X-Zr (X = Cu, Zn, Mg) aluminum alloys;Materials Characterization;2024-09

5. Optimizing recrystallization behavior induced by Mn micro-alloying for reduced anisotropy in rolled Al–Cu–Li alloys;Materials Science and Engineering: A;2024-09