Methods for Improving Foot Displacement Measurements Calculated from Inertial Sensors

Abstract

The use of inertial sensors to measure human movement has recently gained momentum with the advent of low cost micro-electro-mechanical systems (MEMS) technology. These sensors comprise accelerometer and gyroscopes which measure accelerations and angular velocities respectively. Secondary quantities such as displacement can be obtained by integration of these quantities, a method which presents challenging issues due to the problem of accumulative sensor errors. This chapter investigates the spectral evaluation of individual sensor errors and looks at the effectiveness of minimizing these errors using static digital filters. The primary focus is on the derivation of foot displacement data from inertial sensor measurements. The importance of foot, in particular toe displacement measurements is evident in the context of tripping and falling which are serious health concerns for the elderly. The Minimum Toe Clearance (MTC) as an important gait variable for falls-risk prediction and assessment, and therefore the measurement variable of interest. A brief sketch of the current devices employing accelerometers and gyroscopes is presented, highlighting the problems and difficulties reported in literature to achieve good precision. These have been mainly due to the presence of sensor errors and the error accumulative process employed in obtaining displacement measurements. The investigation first proceeds to identify the location of these sensor errors in the frequency domain using the Fast Fourier Transform (FFT) on raw inertial sensor data. The frequency content of velocity and displacement measurements obtained from integrating the inertial data using a well known strap-down method is then explored. These investigations revealed that large sensor errors occurred mainly in the low frequency spectrum while white noise exists in all frequency spectra. The efficacy of employing a band-pass filter to remove a large portion of these errors and their effect on the derived displacements is elaborated on. The cross-correlation of the FFT power spectra from a highly accurate optical measurement system and processed sensor data is used as a metric to evaluate the performance of the band-pass filter at several stages of the processing stage. The motivation is that a more fundamental method would require less computational demand and could lead to more efficient implementations in low-power and systems with limited resources, so that portable sensor based motion measurement system would provide a good degree of measurement accuracy.