Analysis on the hot deformation flow stress curves of novel 6082 aluminium alloys with Mn addition

Abstract

Abstract Two types of 6082 alloy, base alloy free of Mn and novel 0.75Mn alloy with an addition of 0.75% Mn, were prepared. A heat treatment of 450 °C for 6 h was performed, during which large numbers of α-Al (Fe, Mn) Si dispersoids precipitated in 0.75Mn alloy. Uniaxial compression tests were carried out and a series of flow stress curves were obtained at temperature range of 400-550 °C and at strain rate range of 0.001s-1-1s-1. The results revealed an impressive difference between the flow stress curves of base and 0.75Mn alloy that after the yield plateau, the flow stresses of base alloy remained fairly steady at certain levels while the flow stress in 0.75Mn alloy decreased along with strain until the end of deformation. The reason for the decrease of flow stress in 0.75Mn alloy was neither the dissolution of dispersoids nor the dynamic recrystallization. The decrease of flow stress was attributed to the loss of Mn solid solution strengthening effect based on the Mn diffusion rate-controlling mechanism and “pipe diffusion”.