Preparation of CF/PEEK and Study on Friction Performance-Reference-Cited by-同舟云学术

Preparation of CF/PEEK and Study on Friction Performance

Published:2021-03-01 Issue:3 Volume:714 Page:032052
ISSN:1755-1307
Container-title:IOP Conference Series: Earth and Environmental Science
language:
Short-container-title:IOP Conf. Ser.: Earth Environ. Sci.

Author:

Gao Pengyuan,Wang Yanjun,Meng Dezhang,Zhou Xin,Liu Lei

Abstract

Abstract Vacuum sintering technology is used to prepare PEEK composite materials. The friction and wear test of polyether ether ketone (PEEK) and its composite materials under different temperature and dry friction conditions was carried out using a ball-disk friction and wear test machine. Scanning electron microscope and white light total threedimensional profiler were used to observe the surface morphology of the material before and after wear, and compare the material surface before and after the experiment, Study the effect of carbon fibre content and temperature on the tribology properties of materials. At the same time, the wear mechanism of the material is studied.

Publisher

IOP Publishing

Subject

General Engineering

Link

https://iopscience.iop.org/article/10.1088/1755-1315/714/3/032052/pdf

Reference9 articles.

1. Performance study of PEEK composite water lubricated bearing materials [J];Tingting;Bearings,2015

2. Tribological properties of polyetheretherketone composites after adding polytetrafluoroethylene micropowder [J];Zhenjie;Mechanical Engineering Materials,2018

3. Study on the friction and wear behavior of CF / PEEK composites [J];Zhiyi;Journal of Sun Yat-sen University (Natural Science Edition),1996

4. The friction and wear behavior of PEEK composites in different water environments [J];Wancheng;Lubrication and Sealing,2019