Abstract
Online measurement of disk part dimensions by the standard industrial camera features low cost, high efficiency and good universality, but the impact of projection distortion and end face chamfer on measurement is needed to overcome. Present work presents a measurement method to resolve above issues based on machine vision. To improve the measurement accuracy, lower end face of a disk part is determined as calibration plane and the upper end face is measurement plane. To reduce the impact of projection distortion and chamfer on measurement, the measurement points are reconstructed on the measurement plane by re-projection. Then, the inner and outer diameters of disk parts are measured by circle geometric fitting, and the thickness is calculated by the measurement plane position. The experimental results show that the method can online measure disk part dimensions just by a single image, and accuracy meets the requirements of universal grade disk parts.
Funder
Changchun Guanghua University Research Fund Cultivation Project
Publisher
Public Library of Science (PLoS)
Reference24 articles.
1. Bearing defect inspection based on machine vision;H. Shen;Measurement,2012
2. Shaft Diameter Measurement Using Structured Light Vision;S.Y. Liu;Sensors,2015
3. A non-contact high precision measuring method for the radial runout of cylindrical gear tooth profile;Y. C. Pei;Mech. Syst. Signal Process.,2020
4. Vision measuring method for the involute profile of a gear shaft;J. W. Miao;Appl. Opt.,2020
5. Block thickness measurement of using the structured light vision;F. H. Lian;Int. J. Pattern Recognit. Artif. Intell.,2019