1. Ablyaz, T.R., Khanov, A.M., and Khurmatullin, O.G., Sovremennye podkhody i tekhnologii elektroerozionnoi obarabotki materialov (Modern Approaches and Technologies of EDM Processing of the Materials), Perm: Perm. Nats. Issled. Politekh. Univ., 2012.
2. Serebrenitskii, P.P., Sovremennye elektroerozionnye tekhnologii i oborudovanie: uchebnoe posobie (Modern Electroerosion Technologies and Equipment: Manual), St. Petersburg: Balt. Gos. Tekh. Univ., 2007.
3. Ablyaz, T.R. and Zhurin, A.V., Influence of wire-cut electrical discharge machining on surface quality, Russ. Eng. Res., 2016, vol. 36, no. 2, pp. 156–158.
4. Ablyaz, T.R., Simonov, M.Y., Schlykov E.S., et al., Surface analysis of bimetal after EDM machining using electrodes with different physical and mechanical properties, Res. J. Pharm., Biol. Chem. Sci., 2016, vol. 7, no. 5, pp. 974–981. http://www.rjpbcs.com/ pdf/2016_7(5)/[119].pdf.
5. Lyubimov, V.V. and Salomatnikov, M.S., Electrodes with double-layer copper coatings on polymer prototyping mandrels for electrophysical-chemical formation, Uprochnyayushchie Tekhnol. Pokrytiya, 2015, no. 3, pp. 30–36.