Quake-DFN: A Software for Simulating Sequences of Induced Earthquakes in a Discrete Fault Network

Abstract

ABSTRACT We present an earthquake simulator, Quake-DFN, which allows simulating sequences of earthquakes in a 3D discrete fault network governed by rate and state friction. The simulator is quasi-dynamic, with inertial effects being approximated by radiation damping and a lumped mass. The lumped mass term allows for accounting for inertial overshoot and, in addition, makes the computation more effective. Quake-DFN is compared against three publicly available simulation results: (1) the rupture of a planar fault with uniform prestress (SEAS BP5-QD), (2) the propagation of a rupture across a stepover separating two parallel planar faults (RSQSim and FaultMod), and (3) a branch fault system with a secondary fault splaying from a main fault (FaultMod). Examples of injection-induced earthquake simulations are shown for three different fault geometries: (1) a planar fault with a wide range of initial stresses, (2) a branching fault system with varying fault angles and principal stress orientations, and (3) a fault network similar to the one that was activated during the 2011 Prague, Oklahoma, earthquake sequence. The simulations produce realistic earthquake sequences. The time and magnitude of the induced earthquakes observed in these simulations depend on the difference between the initial friction and the residual friction μi−μf, the value of which quantifies the potential for runaway ruptures (ruptures that can extend beyond the zone of stress perturbation due to the injection). The discrete fault simulations show that our simulator correctly accounts for the effect of fault geometry and regional stress tensor orientation and shape. These examples show that Quake-DFN can be used to simulate earthquake sequences and, most importantly, magnitudes, possibly induced or triggered by a fluid injection near a known fault system.