A novel non-isolated dual-input DC-DC boost converter for hybrid electric vehicle application-Reference-Cited by-同舟云学术

A novel non-isolated dual-input DC-DC boost converter for hybrid electric vehicle application

Published:2021-02-05 Issue:2 Volume:22 Page:191-204
ISSN:1553-779X
Container-title:International Journal of Emerging Electric Power Systems
language:en
Short-container-title:

Author:

Daya John Lionel Febin¹^ORCID,Dias Jacintha²,Krishna Srinivasan Mohan³^ORCID,Parandhaman Balamurugan⁴^ORCID,Prabhakaran Prajof⁵^ORCID

Affiliation:

1. Centre for Electric Vehicle Incubation and Testing , Vellore Institute of Technology , Chennai , India

2. SELECT , Vellore Institute of Technology , Chennai , India

3. Department of Electrical and Electronics Engineering, Alliance College of Engineering and Design, Alliance University , Bangalore , India

4. School of Electrical Engineering , Vellore Institute of Technology , Chennai , India

5. Electrical and Electronics Enginnering , NITK , Surathkal , India

Abstract

Abstract This paper proposes a novel non-isolated multi-input dc-dc boost converter for electrical vehicle application. A hybrid system balances the power of the system by using two or more sources. The power between the input sources can be flexibly distributed without any distortion. The charging or discharging of the energy storage systems by other input energy sources can also be monitored in a proper manner and is a feasible task. The design consists of only one inductor and the charging and discharging of the energy storage system decides the operation modes of the converter. In this paper, every operating mode has a small signal model that leads to the control system design for the converter. Simulation and experimental results are provided to prove the validity of the converter and the performance of its control system.

Publisher

Walter de Gruyter GmbH

Subject

Energy Engineering and Power Technology

Link

https://www.degruyter.com/document/doi/10.1515/ijeeps-2020-0229/pdf

Reference30 articles.

1. Nahavandi, A, Hagh, MT, Sharifian, MBB, Danyali, S. A non isolated multi input multi output DC–DC boost converter for electric vehicle applications. IEEE Trans Power Electron 2014;30:1818–35.

2. Kumar, L, Jain, S. Multiple-input DC/DC converter topology for hybrid energy system. IET Power Electron 2013;6:1483–501. https://doi.org/10.1049/iet-pel.2012.0309.

3. Kumar, L, Jain, S. A novel multiple input DC-DC converter for electric vehicular applications. IEEE transportation electrification conference and expo (ITEC). Dearborn, MI, USA: IEEE; 2012.

4. Zhang, X, Mi, C. Vehicle power management: modeling, control and optimization. Berlin/Heidelberg, Germany: Springer Science & Business Media; 2011.

5. Ehsani, M, Gao, Y, Longo, S, Ebrahimi, K. Modern electric, hybrid electric, and fuel cell vehicles. Boca Raton, Florida: CRC Press; 2018.

Cited by 12 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. A comprehensive analysis of the optimal GWO based FOPID MPPT controller for grid-tied photovoltaics system under atmospheric uncertainty;Energy Reports;2024-12

2. Performance analysis of drone sqadron optimisation based MPPT controller for grid implemented PV battery system under partially shaded conditions;Renewable Energy Focus;2024-06

3. A Wide-Range Dual-Bridge Non-Isolated Three-Port Converter Based on P1S3 Architecture;2024 5th International Conference on Mechatronics Technology and Intelligent Manufacturing (ICMTIM);2024-04-26

4. A High-Gain and High-Efficiency Three-Port DC-DC Converter Featuring Coupled Inductor and Single Power Switch for Renewable Energy Applications;2024 28th International Electrical Power Distribution Conference (EPDC);2024-04-23

5. A comprehensive analysis of control strategies for enhancing regulation in standalone photovoltaic systems;Energy Reports;2023-11