The use of numerical analysis of the injection process to select the material for the injection molding-Reference-Cited by-同舟云学术

The use of numerical analysis of the injection process to select the material for the injection molding

Published:2021-01-01 Issue:1 Volume:11 Page:963-976
ISSN:2391-5439
Container-title:Open Engineering
language:en
Short-container-title:

Author:

Jachowicz Tomasz¹,Gajdoš Ivan²,Cech Vlastimil³,Krasinskyi Volodymyr⁴

Affiliation:

1. Lublin University of Technology, Faculty of Mechanical Engineering, Department of Polymer Processing , 20-618 Lublin , 36 Nadbystrzycka Str. , Poland

2. Technical University of Kosice, Faculty of Mechanical Engineering, Department of Technologies, Materials and CAx , 042 00 Kosice , 74 Masiarska Str. , Slovakia

3. Technical University of Kosice, Faculty of Mining, Ecology, Process Control and Geotechnology, Department of Logistics and Transport , 042 00 Kosice , 9 Letna Str. , Slovakia

4. Lviv Polytechnic National University, Department of Chemical Technology of Plastics , 79013 Lviv , 12 Bandera Str. , Ukraine

Abstract

Abstract The article presents the methodology of using the results of computer simulation of the injection process to assess the suitability of the material for the injection molding. Computer simulation of the basic phenomena occurring during the filling phase, packing, and cooling phase of the injection molding provides a number of different results, containing typical information both on the suggested technological parameters of the process and on the dimensional accuracy of the molded part, but also allows obtaining data on the production efficiency and energy demand of the processing machine. On the basis of this information, it is possible to assess the suitability of the polymer materials used in the simulation, intended for the production of products from a specific industry, taking into account various criteria, mainly of an economic or qualitative nature.

Publisher

Walter de Gruyter GmbH

Subject

Electrical and Electronic Engineering,Mechanical Engineering,Aerospace Engineering,General Materials Science,Civil and Structural Engineering,Environmental Engineering

Link

https://www.degruyter.com/document/doi/10.1515/eng-2021-0094/pdf

Reference23 articles.

1. Beaumont JP, Sherman R, Nagel RF. Successful injection molding: process, design, and simulation. Munich: Carl Hanser Verlag; 2002.

2. Rosato DV, Rosato DV, Rosato MG. Injection molding handbook. Norwell: Kluwer Academic Publisher; 2000.

3. Xiaoyang Xu, Peng Yu. Modeling and simulation of injection molding process of polymer melt by a robust SPH method. Appl Math Model. 2017;48:384–409.

4. Zhou H. Computer modeling for injection molding: simulation, optimization, and control. Hoboken: John Wiley & Sons Inc; 2013.

5. Fedorko G, Molnar V. Design of a calculation fem model of the test static set-up of pipe conveyor for analysis of contact forces‎. Adv Sci Technol Res J. 2017;11(2):220–5.