Fracture strain improving via structural austenitic stainless steel-coated 22MnB5 plates

Abstract

A total of 316 austenitic stainless steel (ASS) coatings were deposited on 22MnB5 press-hardening steel plates by varying the substrate bias voltages using a magnetron sputtering technique and quenched in a flat mold with cooling water. The substrate bias current and ion-bombardment energy densities increased up to 0.5 mA/mm2 and 50 J/mm2 at a high voltage of −100 V, and, therefore, the variations in the coatings’ morphologies were owing to the increases in the ion bombardment. The porous bulk pattern appeared in the quenched ASS coating at −100 V, clearly different from the porous columnar structure of the others at −50 and −75 V. The γ-Fe and α-Fe phases were observed from the diffraction peaks, presented the ASS coating and 22MnB5 substrate, respectively. There was no intermetallic compound (IMC) peak detected. In addition, the diffusion layer of the quenched ASS-coated plate was observed, in which its morphology was different from the quenched martensite (M) plate, and proved to be the α-Fe microstructure by the very low α-Fe peak at the standard (110) position. The bright image of TEM and the select area electron diffraction pattern indicated the nanostructure of the quenched ASS coating. The nanohardness of the ASS coating, diffusion layer, and M plate (7.36, 3.60, and 6.25 GPa, respectively) was detected, indirectly proving an α-Fe structure of the diffusion layer. The fracture angles of the 316-coated plates significantly improved from 51.82° at −50 V, 53.77° at −75 V to 57.38° at −100 V, as the ASS structure changed to be porous bulk pattern. The clearance of IMC, coating’s porous bulk pattern, and the low hardness α-Fe diffusion layer benefited for the fracture strain by lengthening the pathway of the crack’s development and blocking the further crack’s propagation, respectively.