Effect of hydrate anti-agglomerants on water-in-crude oil emulsion stability

Abstract

AbstractUnder high-pressure and low-temperature conditions, gas hydrate shells may form and grow at the interface of water droplets in water-in-oil emulsions. Such hydrate formation can enable downstream agglomeration and slurry viscosification, thus increasing the risk of hydrate blockage. Therefore, emulsion stability represents a critical parameter in understanding this overall flow behaviour. In this study, the impact of three common and widely-used industrial anti-agglomerants from three different suppliers (AA-1, AA-2 and AA-3—exact composition is commercially sensitive) on 30 wt% water-in-oil (W/O) emulsion stability was investigated. Bench-top nuclear magnetic resonance (NMR) pulsed field gradient (PFG) methods were used to measure the droplet size distributions (DSDs) of the W/O emulsions as a complement to bottle stability test. In the absence of hydrate anti-agglomerants, based on visual observation, 85% of the original W/O emulsion remained after 10 h. In the presence of AA-1 and AA-2, 94% of the original emulsion was retained; in contrast, AA-3 acted to destabilise the emulsion with only 64% of the original emulsion visually evident after 10 h. These results were substantiated by PFG NMR measurements which showed substantial changes in droplet size as a function of sample height for the W/O emulsion formulated with AA-3. Interestingly the W/O emulsion formulated with AA-1, while very stable, was characterised by comparatively very large water droplets, indicative of a complex multiple water-in-oil-in-water (W/O/W) emulsion microstructure. AA-2 forms stable emulsion with small droplets of water dispersed in the oil phase. Our results provide insight into a wide range of potential impacts of AA addition on an industrial crude oil pipeline, in which AA-1 resulted in a complex W/O/W multiple emulsion, AA-2 behaved as an emulsifier and AA-3 behaved as a demulsifier.